Kits
50T Spur Steel Gear (Mod1)
- Product SKU: HRAERVT50M01
- Category: 1.0M Spur Gears, E-Revo Driveline, E-Revo Hopup, E-Revo Parts, Gears, X-Maxx Driveline, X-Maxx Hopup, X-Maxx Parts
- Order within
50t Mod 1 Steel Spur Gear E Revo 2 X-Maxx XO-1
ERVT50M01
Hot Racing 50 tooth hardened steel Mod 1 (1.0 metric pitch) spur gear for the Traxxas E Revo2, X-Maxx 6S and 8S, Maxx 4S and XO-1.
FEATURES:
- CNC machined hardened steel construction
- Black oxide finished
- Laser etched tooth count marking
YOU WILL RECEIVE:
- One (1) 50T, 1 mod steel spur gear
REQUIREMENTS:
- Do NOT use the pin system for setting the X-Maxx gear mesh. Instead, manually set the gear mesh without the pins. Refer to the Traxxas manual for instructions (ref. pg.22 - Adjusting Gear Mesh)
- With the pins removed, use the four 4x16mm button-head cap screws on the bottom to set gear mesh. Loosen the four 4x16mm button-head cap screws. Cut a narrow strip of notebook paper and run it into the gear mesh. Slide the motor and pinion gear into the spur gear. Tighten the four 4x16mm button-head cap screws, and then remove the strip of paper. You should be able to run a fresh strip of paper through the gears without binding them.
SPECIFICATIONS:
- Overall diameter: 52.8mm
- Gear face width: 8mm
COMMENTS:
- Upgrade for factory plastic 6448 or 6448X 54T spur gear
50t Mod 1 Steel Spur Gear E Revo 2 X-Maxx XO-1
ERVT50M01
Hot Racing 50 tooth hardened steel Mod 1 (1.0 metric pitch) spur gear for the Traxxas E Revo2, X-Maxx 6S and 8S, Maxx 4S and XO-1.
FEATURES:
- CNC machined hardened steel construction
- Black oxide finished
- Laser etched tooth count marking
YOU WILL RECEIVE:
- One (1) 50T, 1 mod steel spur gear
REQUIREMENTS:
- Do NOT use the pin system for setting the X-Maxx gear mesh. Instead, manually set the gear mesh without the pins. Refer to the Traxxas manual for instructions (ref. pg.22 - Adjusting Gear Mesh)
- With the pins removed, use the four 4x16mm button-head cap screws on the bottom to set gear mesh. Loosen the four 4x16mm button-head cap screws. Cut a narrow strip of notebook paper and run it into the gear mesh. Slide the motor and pinion gear into the spur gear. Tighten the four 4x16mm button-head cap screws, and then remove the strip of paper. You should be able to run a fresh strip of paper through the gears without binding them.
SPECIFICATIONS:
- Overall diameter: 52.8mm
- Gear face width: 8mm
COMMENTS:
- Upgrade for factory plastic 6448 or 6448X 54T spur gear
